SATO GL4XXE Guida di Installazione Scaricare il pdf (Pagina 5)

Simple-Dispenser Installation Guide

GL4xxe Simple-Dispenser Installation

The Simple Dispenser comes with its own front cover to replace the factory-installed

front cover of the GL4xxe series printer. Follow the procedures below to install the

Simple Dispenser.

1. Make sure the printer is OFF and disconnected from the power supply.

2. Lift up the side cover to access the original housing cover (1).

3. Remove the original housing cover by unscrewing the thumbscrew (2) at the

side of the printer.

Figure 1. Removing the existing front cover and preparing to install the replacement cover.

1 2 3 4 5 6 7 8

Nessun commento

SATO GL4XXE Guida di Installazione Pagina 5